Fireboxes

Linea VZ fireboxes offer the fascination of a fireplace. They have been designed to achieve a high heat recovery and low consumption, benefitting the environment, while still guaranteeing the pleasant atmosphere that conjures up the age-old feelings aroused by the heat and the sight of a fire burning in the home. Available in various models, these are the ideal system for heating several rooms.

dis_monoblocchi_eng

Installation tips

1. Check the catalogue to make sure the chosen firebox is suitable for the intended environment. Specifically, check and prepare:

  • inside diameter of the flue;
  • flue height, from ceiling to chimney pot;
  • size of the outdoor air intake.

2. Preferably install the fireplace on a finished floor.
3. For details on installing the product, strictly follow the instructions provided.
4. Following installation, before fitting the lining hood, make sure that all the slide mechanisms (which automatically adjust the valve) are working. Then light the fire the first time..
When there is optimum combustion in the firebox, slowly slide the door up, with a slight pause at the beginning, and down again. Also make sure that the swing opening system is not held shut by the lining. Repeat the operation more than once to make sure the firebox has optimum draught. If draught is not optimum, turn the nut positioned above the door that adjusts the valve, until achieving perfect draught.

The reasons for a choice

monob1
monob2

Exceptional heating

The high heat efficiency of this series of products is ensured by the following technical features:

  • all models have a radiant surface area of 2.24 m2, much higher than similar products;
  • all the parts of the combustion chamber and the hood exchange heat;
  • the tube bundle, made up of three tubes, is located at the top of the combustion chamber to best absorb the heat generated by combustion.

Operation

The air taken in from the outside and from the inside through the special air intakes, is heated in the heating chamber at the rear and top and then blown into the room by the fan.

Heating multiple rooms

By ducting the warm air, several rooms in the home can be heated at the same time. This can also be done by installing a special Y-joint to distribute heat through two additional outlets. Suitable ducting needs to be installed, as follows:

  • Insulated steel / aluminium pipes, maximum length 3-4 m;
  • Trunking in a 20x25 cm inner section galvanized steel, suitably insulated, for a development up to 10 m.

Perfect draught

VZ fireboxes allow optimum management of combustion and flue draught thanks to a special screw register, positioned above the slide-up door on the appliance.

Simply turn it clockwise or anticlockwise to ensure perfect draught even when the flue is undersized or in unfavourable atmospheric conditions (low pressure). The flue gas outlet valve is managed automatically to prevent smoke from leaking out when opening the door.

Controlled consumption

The combustion air register, positioned on the firebox door, can be used to easily adjust the intensity and duration of the flame, so as to control consumption in the best way for all needs.

Ventilation

The 800m3/h fan is started automatically by a temperature probe when the outlet air temperature exceeds 50 degrees, and stops automatically when the temperature falls below 50 degrees; fan motor speed is managed by a speed controller in the electronic control unit. The fan is positioned underneath the firebox and can be inspected from inside the firebox by removing the combustion chamber cast-iron or refractory plates, without needing to remove the lining. The air outlets are white, and fitted with dampers to adjust air flow.

Safe, solid and reliable

The fireboxes are made from a 3 mm thick steel body, are safe, solid and reliable, and have been designed and built to last in time and achieve high efficiency. The combustion chamber, bottom and walls are made using multiple plates that allow natural expansion due to the heat developed inside.
These plates are available in two materials:

  • cast-iron combustion chamber: made using over 70 kg of 8 mm thick plate.
  • refractory combustion chamber: made using over 70 kg of 4 cm thick plate. (Ideal for cooking food)

Both materials can accumulate the heat produced and then deliver it gradually by radiation and convection.
The door with double opening (slide-up for loading the wood, swing for cleaning) is made from ceramic glass with exceptional heat resistance (toughened at 800°C) and an elegant handle. The door is balanced by a counterweight on chains, sprockets and bearings, and slides on machined guides and self-lubricating bushings to guarantee minimum friction and low noise.

Fireboxes
9 Fireboxes

Giove

  • Nominal heat output Kw 10.0
  • Overall efficiency 77,50%
  • Optimal wood consumption Kg/H 3
  • Fan mc/h
...

Curvo 60

  • Nominal heat output Kw 10.0
  • efficiency 77,50%
  • Optimal wood consumption Kg/H 3
  • Fan mc/h
...

BELVEDERE 80

  • Nominal heat output Kw12,5
  • Overall efficiency 75%
  • Optimal wood consumption Kg/H 4-5
  • Fan mc/h
...

BELVEDERE 60

  • Nominal heat output Kw 10.0
  • Overall efficiency 77,50%
  • Optimal wood consumption Kg/H 3
  • Fan mc/h
...

PANORAMICO 80

  • Nominal heat output Kw12,5
  • Overall efficiency 75%
  • Optimal wood consumption Kg/H 4-5
  • Fan mc/h
...

ANGOLARE 80 R/L

  • Nominal heat output Kw12,5
  • Overall efficiency 75%
  • Optimal wood consumption Kg/H 4-5
  • Fan mc/h
...

BELVEDERE 95

  • Nominal heat output Kw16,5
  • Overall efficiency 75%
  • Optimal wood consumption Kg/H 5-6
  • Fan mc/h
...

PANORAMICO 95

  • Nominal heat output Kw16,5
  • Overall efficiency 75%
  • Optimal wood consumption Kg/H 5-6
  • Fan mc/h
...

ANGOLARE 95 R/L

  • Nominal heat output Kw16,5
  • Overall efficiency 75%
  • Optimal wood consumption Kg/H 5-6
  • Fan mc/h
...

LineaVZ Logo
LINEA VZ SRL
Via Abate Tommaso, 90
30020 Quarto d’Altino (VE) - Italy
Tel. +39 0422.780750
Fax +39 0422.780097
P. IVA IT03726870276

info@lineavz.it